An air receiver is integral part of compressed air system to provide pulsation free flow in the discharge line .It serves a reservoir for momentary demands in excess of compressor's output. It also helps to condense vapour form moisture in compressed air .
Design & manufacturer to standards such as IS 2825, ASME Sec VIII Div I or as per customers requirements.
Type of Receivers :
Install after cooler near to compressor with clean and treated water supply and effective cooling for re-circulating water.
Scope of Supply :
Vertical and Horizontal.
Installation :
For effective utilization place receiver in the coolest place. Sufficient access must be provided to allow visual inspection all round the air receiver shell.
Scope of Supply :
All receivers are supplied with pressure relief valve, pressure gauge, drain valve and foundation bolts.
Air Receiver
Material :
Operating Pressure :
IS 2062, SA 515 Gr 70 or as customers' requirement.
Nominal 7 Kg/cm2 g. up to 50 Kg/cm2 g.
Volume capacity :
25 liters to 15000 liters.
Optional Tests :
Material :
Physical & Chemical tests.
Welder's Qualification in presence of customer if needed.
Weld Examination:
Dye Penetrant.
X ray/ gamma rays.
Magnetic particle.
1.5 times max operating pressure or design pressure.
Hydro Testing
For your specific requirement of after cooler to meet either your process requirements, or pressure, or material or design standard or inspection requirements please contact or write to registered office.
